Omschrijving This DIY LiPo Supercharger/Booster (developed the electronics engineer/YouTuber GreatScott! and produced by Elektor) can charge a single-cell LiPo battery and protect it against the effects of overvoltage, overload, and short-circuits. Additionally, it can boost the battery voltage to 5 V or 12 V. The boosted output voltage is protected by an ‘eFuse’ IC outputting 1.52 A at 5 V or 0.76 A at 12 V maximum.
The charger part of the circuit needs a +5 V power supply which can be connected through USB-C, or simply two wires soldered to pads on the PCB.
In addition, other connections can be soldered to pads on the PCB or by using single pinheaders.
Included
1x Mainboard pre-assembled with the 4 ICs
15x Resistors
3x LEDs
13x Capacitors
2x Switches
1x USB-C on a breakout board
2x Diodes
Please note: Battery is not included.
The board uses a DC/DC Converter, an IC charger, and an e Fuse from Texas Instruments. The battery protection IC is from Xysemi and provides under-voltage lockout, over current protection, and reverse battery protection.
The board is connected to the power and recharges the batteries via a USB-C connection.
Specifications
Battery
Single-cell lithium-ion or lithium-polymer battery
Input Voltage
+5 V / 2 A max.
Output Voltage
5 V / 1.52 A
LiPo Protection
XB8089D
Overcharge Detection
4.250 V
Overcharge Release
4.10 V
Overdischarge Detection
2.50 V
Overdischarge Release
3 V
Overcurrent Detection
10.0 A
Thermal Shutdown
Auto-retry
Enable/Undervoltage Lockout
Rising: 1.2 V (typ.)
VIDEO
