Elektor Modules

2 producten


  • Elektor SDR-shield 2.0

    Elektor Labs Elektor SDR-shield 2.0

    Dit bord is een nieuwere versie van de Elektor SDR Reloaded, het verschil is dat op deze nieuwe versie met twee PLL-uitgangen en twee LF-uitgangen, die toegankelijk zijn via extra connectoren op het bord (niet inbegrepen in de kit). Hierdoor kan de gebruiker dit Arduino schild gebruiken als een signaal generator, SW zender of zelfs transceiver. Specificaties Bedrijfsspanning 5 V en 3,3 V van Arduino Frequentiebereik 150 kHz tot 30 MHz Gevoeligheid 1 µV Overal Gain 40 dB Maximum signaalniveau bij antenne 10 mV Dynamisch bereik 80 dB Let op: de module wordt niet voorgesoldeerd geleverd. Links Elektor SDR-shield 2.0 (1) Elektor SDR-shield 2.0 (2) Elektor SDR-shield 2.0 (3)

    € 39,95

    Leden € 35,96

  • USB-RS232 Converter (FT231X BoB)

    Elektor Labs USB-RS232 Converter (FT231X BoB)

    In 2011 we published a small PCB, FT232R USB/Serial Bridge/BOB (110553) with a USB-UART IC from FTDI, the FT232RQ. Here we present its successor with a cheaper version, an FT231XQ. But there are some other changes too. Instead of connectors, alongside the PCB, normal pin headers are used that are mounted on the bottom side and make the PCB a little smaller when mounted, compared to the old BoB. An ESD protection device (D1) is added in the USB data signal lines for extra safety. Despite less room for all parts to fit on the PCB, it is only a little over 2 mm longer. The FT231 has four configurable CBUS I/O pins, one less now. More importantly, however, the power supply for the I/O's VCCIO is only specified for +1.8 V to +3.3 but is 5 V tolerant for external UART logic running on +5 V. The +3.3 V internal regulator of the FT231 can deliver 50 mA to external circuitry. The manufacturer FTDI has a utility to configure several settings, FTPROG. Such as the function of the CBUS pins. By default, CBUS1 and CBUS 2 are low-level outputs to drive receive and transmit LEDs, indicating data transfer on the USB bus. So, when receiving data through the UART, the TX LED lights up. If you prefer this the other way around, FTPROG can be used to change this. But be careful the chip can become unresponsive when wrong settings are programmed. Some of the more important properties of the new BoB: Micro-USB connector USB 2.0 Full Speed capable VCCIO +1.8...+3.3 V (max. 4 V, 5 V input from UART logic tolerant) +3.3 V regulator output, max. 50 mA Data transfer 300 baud to 3 Mbaud UART Compatible with RS232, RS485, and RS422 I/O pin output drive 4 mA - 16 mA 4 configurable CBUS pins Here you can find information regarding the EEPROM Programming Utility, the VCP Drivers and the D2XX Drivers.

    € 19,95

    Leden € 17,96

Login

Wachtwoord vergeten?

Heb je nog geen account?
Maak gratis een account aan en geniet van vele voordelen.