NIEUW
MonkMakes Electronics Notebook
Specifications A4 (210 x 297 mm) squared-grid spiral-bound notebook with watermark breadboards 158 pages, card covers. The book also includes Microcontroller programming cheat sheet Common circuits and calculations Pinouts Resistor color codes ASCII table
€ 16,95
Leden € 15,26
MonkMakes MonkMakes Plant Monitor
Monitor soil moisture, temperature and relative humidity measurement with the Plant Monitor. This board is compatible with the BBC micro:bit, Raspberry Pi and most microcontroller boards. Alligator / croc clip rings Ready soldered header pins for your choice of microcontroller. Easy to use UART serial interface Additional analog output for moisture only Built-in RGB LED Downloads Datasheet Instructions
€ 14,95
Leden € 13,46
MonkMakes MonkMakes Electronic Starter Kit for micro:bit
This kit contains everything needed to start learning about connecting electronics to the micro:bit in an accessible and easy manner. Everything is connected using the supplied alligator clips, so no soldering required. Included MonkMakes Speaker for micro:bit MonkMakes Switch for micro:bit MonkMakes Sensor Board for micro:bit Set of alligator clip leads (10 leads) Small motor with fan Single AA battery box (battery not included) Light bulb and holder Booklet (A5) Downloads Instructions Datasheet Lesson Plans
€ 39,95
Leden € 35,96
MonkMakes MonkMakes Amplified Speaker Kit for Raspberry Pi
The Speaker Kit for Raspberry Pi is a small amplified speaker designed for the Raspberry Pi. Included MonkMakes Amplified Speaker Set of 10 female to female header wires Short stereo audio lead Raspberry Leaf GPIO template Downloads Instructions Datasheet
€ 19,95
Leden € 17,96
MonkMakes MonkMakes Servo Kit for Raspberry Pi
This kit includes 2 servo motors and a Monk Makes ServoSix interface board for use with Raspberry Pi. It also includes a Raspberry Leaf GPIO template, a bunch of female-to-female header pins and a 4xAA battery box.Features of the Servo Six board Screw terminals for servo power supply Reverse-polarity protection for the servo power supply 470 µF 16 V capacitor for servo supply 470 ? current limiting resistors for servo control lines (to protect GPIO pins) Power indicator LE DownloadsInstructions
€ 24,95€ 19,95
Leden identiek
MonkMakes MonkMakes Air Quality Kit for Raspberry Pi
The board has a display of six LEDs (green, orange and red) that display the air quality and a buzzer. Temperature and air quality readings can be read by your Raspberry Pi, and the buzzer and LED display can also be controlled from your Raspberry Pi. The Air Quality Sensor board plugs directly into the back of a Raspberry Pi 400, but, can also be used with other models of Raspberry Pi, using the jumper wires and GPIO template included in the kit. It uses the CCS811 VOC sensor IC and a TMP235 temperature sensor. It also has a rudimentary display and a buzzer. It also uses a bi-directional UART interface to communicate with the Pi. The Air Quality Sensor board is designed for use with the Raspberry Pi 400 but also works with other models of Raspberry Pi using the jumper wires included in the kit. Downloads Instructions Datasheet
